Nuclear control 2 wiki3/6/2023 Sneak+Right Click with wrench allows to rotate Information Panel around an axis.Ĭomponents to build large screens for your control room. Block can be rotated and removed with wrench. You can configure set of parameters to display via GUI. Use redstone signal to turn it on and off. Panel shouldn't be attached to energy net. Information panel also supports range upgrades. Panel block, which shows multiple parameters from data source card. You can use this item to increase range of the Remote Thermal Monitor and Reactor Information Panel. Allows to display time data on panels and screens. Industrial Information Panel data source. If you don't need Energy Array Location Card - you can get back 2 circuits per each Energy Sensor Location Card in the array. To add new Energy Sensor Location Cards to the Array - combine them with Crafting Table. Energy Array Location Card can be used as data source for Industrial Information Panel. To receive Array card you should combine 2 to 6 Energy Sensor Location Cards on your Crafting Table. Card which contains multiple Energy Sensor Location Card. If you don't need Energy Sensor Location Card any more - you can get back 2 circuits (shapeless crafting recipe). Supported storages: BatBox, MFE, MFSU, Lapotron Energy Storage Unit. Sensor Location Card should be placed to the Industrial Information Panel as data source. Use a kit on energy storage (right click) to mount a sensor and receive location card. Pair of remote sensor and Energy Sensor Location Card. If you don't need Reactor Sensor Location Card any more - you can get back 2 circuits (shapeless crafting recipe). Reactor Sensor Location Card should be placed to the Remote Thermal Monitor in top-right slot or to the Industrial Information Panel as data source. Use a kit on reactor (right click) to mount a sensor and receive location card. Pair of remote sensor and Reactor Sensor Location Card. It should be charged after crafting and can be recharged. Regular thermometer measures the temperature of a reactor (right click on reactor or on reactor chamber).ĭigital thermometer measures the temperature of the reactor and displays other temperatures (water evaporation point, reactor melting point). Sneak+Right Click with a wrench allows to rotate Remote Thermal Monitor around an axis. It also indicates if reactor can't be found or too far with bluish gray color. When machines do not have enough power, an indicator has a dark gray color. You can adjust facing of indicator with IC2 wrench. As additional feature this machine shows a progress bar of reactor heating (100% is a signal level). To increase range - use Range Upgrade item. Signal from remote sensor can be received on the distance up to 8 blocks in each direction from reactor. Power can be supplied via wires or with energy storage items from IC2 (battery, Energy Crystal etc.). Energy storage and max packet size can be increased with energy storage and Transformer Upgrades. Default energy storage is 600 EU, max packet size before explosion is 32 EU/p. Energy consumption can be increased via the remoteThermalMonitorEnerg圜onsumption config parameter. Instead it requires Sensor Location Card (a part of Remote Sensor Kit, described below) and consumes 1 EU/t. It doesn't require direct connection to Nuclear reactor. Thermal Monitor has three indicator colors: If 2 or more reactors are placed near Thermal Monitor, then only first found will be checked for heat level. When searching for reactor, it checks only one block in each direction. Thermal Monitor block should be placed either directly on your reactor/reactor chamber or on any block near it. Use Sneak + Right click to prevent GUI from opening. You can set any temperature in the range 0-15000 with step 100. If reactor reaches specific heat level, Thermal Monitor changes color of indicator to the red and emits redstone signal. Thermal Monitor measures heat level of Nuclear Reactor.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |